Preparations for the construction of the beams.

December 11, 2011

For this winter I have planned to build the four beams in my garage at home. De beam molds are ready and one of the first parts I need are the upper folding strut recess sides. These are made of pre-made 4mm. thick solid laminate. For the eight pieces and some smaller doublers I vacuum infused a 4’x6′ solid laminate plate.

The low viscosity epoxy resin starts to gel after 300 minutes so there is enough time for a simple version of the infusion setup. Below three photos of the infusion, the first after 15 min, than 1 hour and the bottom one after 1.5 hour.

15 min. after start of infusion1 hour after the start of the infusion1.5 hour after the start of the infusion

There are also some new photos in this galery.


Epoxy sensitivity.

February 11, 2003

Some thoughts about epoxy sensitivity


%d bloggers like this: